Webb WEPT360MM - MAINTENANCE, CLEANING & STORAGE; MAINTENANCE; SPARK PLUG; LUBRICATION

MAINTENANCE, CLEANING & STORAGE
WARNING
Improper maintenance & storage of the machine may void your warranty. Keep the machine clean for better
and safer performance.
Turn off the engine before performing any maintenance. If the engine must be run, make sure the area is
well ventilated. The exhaust emits dangerous carbon monoxide gases.
MAINTENANCE
• Before each use, check all nuts & bolts to be sure they are sufficiently tightened.
• We recommend only manufacturer original parts are used when maintaining this machine. Failure to do so
could invalidate your manufacturer’s warranty.
• The engine must be switched off, with the spark plug cap removed, before the machine is unassembled,
cleaned, serviced or maintained.
SPARK PLUG
• Use only original replacement spark plug. For best results, replace the spark plug every 100 hours of use.
• Do not attempt to remove the plug from a hot engine in order to avoid possible damage to the threads.
• Clean or replace the plug if fouled with heavy oily deposits. Recommended gap of the spark plug electrode
is 0.70‐0.80mm.
• Replace the plug if the center electrode is worn or rounded at the end.
LUBRICATION
• WHEELS ‐ Lubricate the ball bearings in each wheel at least once a season with a light oil.
• ENGINE ‐ Follow the separate engine manual for lubrication instructions.
Daily
First
Month or
20 Hours
Every
3 months or
50 Hours
Every
6 months or
100 Hours
Every
Year or
300 Hours
Engine Oil
Check Level
0
Change
0
0
Air Filter (1)
Check
0
Clean
0
Fuel Strainer
Cup
Clean 0
Spark Plug
Clean or
Readjust
0
Gearbox Oil
Check Level
0
Tappet
Clearance (2)
Check or
Readjust
0
Fuel Tank &
Strainer
Clean 0
Clutch Cable
Adjust
0
0
Throttle Cable
Adjust
0
Belt Tension (2)
Adjust
0
0
Fuel Line
Check
Every 2 years (Replace if necessary)
NOTE:
1. Check more frequently when used in dusty areas.
2. These items should be serviced by an authorised dealer.
INSTRUCTION MANUAL