PRE-OPERATION
FUEL & OIL
WARNING
YOUR MACHINE IS SUPPLIED WITHOUT ENGINE OIL OR PETROL
Operating the engine with insufficient oil can have catastrophic consequences. Any failure caused by
insufficient oil, will not be covered by the manufacturer’s warranty.
Read instructions carefully.
Fuel & its vapors are very flammable. Do not use or fuel the machine near a flame, sparks or while smoking.
Allow the engine to cool for more than 3 minutes, before re-fueling. Never fuel the machine with the engine
running. Fuel the engine at least 15 metres away from your work area. Always fuel your machine outdoors.
IMPORTANT:
Fuel which is older than 30 days old can become stale and cause acid & gum deposits in the fuel system or
essential carburettor components. This could result in starting issues which would not be covered by the
manufacturer’s warranty.
Ensure that any stored petrol is clearly marked in a separate appropriate canister for a maximum of 30 days
if not mixed with a fuel additive. If the machine is not going to be used for a long period, drain the petrol
from the fuel tank, start the engine and drain the carburetor of any remaining fuel.
To keep fuel fresh, we recommend you use SURE-START FUEL ADDITIVE (HP-199) from Handy Parts. A fuel
additive you add to your fuel, which will help make your machine easier to start, extend the shelf life of your
fuel for up to two years, keeps the carburettor & engine clean, plus reduces emissions and increases fuel
economy. A 250ml bottle of SURE-START FUEL ADDITIVE will treat 25 litres of fuel.
ADD FUEL
1. Place the machine onto a solid flat surface, ensuring the engine is OFF.
2. Unscrew the fuel cap slowly and fill the fuel tank with unleaded petrol with an Octane rating of 86 or
higher.
3. Fill to a maximum of 80% capacity. This will allow the fuel tank to expand.
4. Fasten the fuel cap tightly (2), being careful not to cross-thread. This will also prevent loosening through
vibration during use.
5. Wipe away any spillage, with an appropriate material.
6. If the machine has continued leaks, the product should not be started.
7. Never use the machine with damaged ignition cable or spark plug cap, as there is a risk of sparks.
1. Pull the trimmer shield out into position by pivoting and lining up the holes.
2. Secure with the three bolts and nuts supplied and fasten it to the main body of the machine as imaged
To Next Page
Loading...
