Webb WEELT650 - User Manual

Questions and Answers

S
Steve StricklandAug 3, 2025
What to do if my Webb Trimmer line won't advance after restarting?
- R
  Ruth WilliamsAug 3, 2025
  If the line on your Webb Trimmer isn't advancing, there could be several reasons. First, the line might be welded to itself; try lubricating it with a silicone spray. Second, there might not be enough line on the spool, so you should install more line. Third, the line might be worn too short; try pulling the lines while pressing and releasing the bump button. Finally, the line could be tangled on the spool; in this case, remove the line and rewind it.
J
Jack GonzalesAug 11, 2025
Why my Webb WEELT650 Trimmer stops and will not start again?
- S
  Sandra Miller DDSAug 11, 2025
  There are a couple of reasons why your Webb Line Trimmer might stop and not restart. It could be due to unit failure, in which case you should contact your dealer to check for damage. Alternatively, the plug might be damaged, so it's a good idea to check the plug.
K
Keith BrownAug 18, 2025
What to do if the cutting head of my Webb WEELT650 is hard to turn?
- R
  Rachael RichardAug 18, 2025
  If the cutting head on your Webb Trimmer is hard to turn, it's likely due to grass wrapped or built up around the head. Clean the affected parts of the machine to resolve this.
N
Natasha JimenezAug 26, 2025
How to prevent grass from wrapping around the shaft of my Webb Trimmer?
- J
  Joseph BellAug 26, 2025
  To prevent grass from wrapping around the attachment shaft and trimmer head assembly of your Webb Trimmer, especially when cutting tall grass, cut the grass from the top down.