Webb WEELT650 - CLEANING & MAINTENANCE; Pre-Use Checks; Periodic Maintenance; Troubleshooting Guide

CLEANING & MAINTENANCE
DANGER
Prior to conducting maintenance or cleaning: Unplug from the power source.
Note: Clean unit immediately after every use. Remains of dried grass is very hard, and are very
difficult to remove.
BEFORE EACH USE
What?
How?
Check the power cable and connector for
damage.
Conduct a visual inspection and have the
cable replaced by an electrician if necessary.
IF NECESSARY
What?
How?
Cleaning the device
Wipe the unit with a damp cloth.
Replace the thread if it is too short.
Replace the spool
STORAGE & TRANSPORTATION
STORAGE
Store the tool in a dry and well-ventilated place.
TRANSPORTATION
When transporting, try to use the original packaging, if possible.
TROUBLE SHOOTING
Error/Fault
Cause
Remedy
Line will not advance when you
restart the machine.
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
1. Lubricate with a silicone
spray.
2. Install more line (Refer to
“Replacing the Cutting Line”).
3. Pull lines while alternately
pressing down on and
releasing bump button.
4. Remove line from spool and
rewind (Refer to “Replacing
the Cutting Line”).
Cutting head is hard to turn
Grass wrapped or built up
around head.
Clean affected parts of the
machine.
Grass wraps around the
attachment shaft and the
trimmer head assembly
Cutting tall grass at ground
level.
Cut tall grass from the top
down.
Line trimmer stops and will not
start again
1. Unit failed
2. Plug is damaged.
1. Contact dealer to check
damage
2. Check the plug
If you can’t fix the fault yourself, contact your retailer. Please be aware that any improper
repairs will also invalidate the warranty and additional costs may be incurred.
INSTRUCTION MANUAL
WEELT650 Instruction Manual.indd 15 17/11/2017 10:11