switching on the line trimmer, the inertia of the head
ll feed a small length of line out. An ‘impact’ noise
heard when both nylon lines hit the cutting knife, this is
a minimal period, the nylon line will be cut to the
correct length and the noise will redu
speed. Make sure the motor is up to full speed before
If the noise of the nylon line being cut cannot be heard,
line will need to be fed out.
To feed more line, it is first
allow the machine to stop completely, then re-
can manually feed out the nylon line. To do this, press &
feed button, whilst pulling on one of the nylon lines.
until the line reaches the cutting knife. Gently pull on the
do not press the manual line feed button again). If the
cutting knife, remove the spool cap and click
spool anti-clockwise until the line is at the desired length.
CUTTING TIPS
For the correct cutting action, swing the line trimmer from side to side as you walk forward,
holding it at an angle of approx. 20° as you do so. (G)
Cut long grass from top to bottom to ensure that the grass does not get tangled around the
spool (H)
Only cut with the left (shown here as light grey) area of the cutting unit when the unit is being
moved from right to left.
In the right (dark grey) area, the threads rotate in your direction.
This represents a high level of kickback risk and objects may be thrown in your direction by the
rotation of the thread. You may be hurt as a result.
WEELT650 Instruction Manual.indd 13 17/11/2017 10:11
To Next Page
Loading...
