23
OPC/Brake lever disengaged.
Spark plug cap disconnected.
Connect spark plug cap to spark
plug.
Fuel tank empty or stale fuel.
Fill tank with clean, fresh petrol.
Prime engine as instructed in the
Operation section.
Clean, adjust gap, or replace.
Remove spark plug, clean with
clean cloth and refit.
Connect and tighten spark plug
cap.
Blocked fuel line or stale fuel.
Clean fuel line; fill tank with clean,
fresh petrol.
Vent in fuel cap plugged.
Water or dirt in fuel system
Drain fuel tank. Refill with fresh
fuel.
Fill crankcase with proper oil.
Clean area around and on top of
engine.
Occasional skips (hesitates) at
high speed
Spark plug gap too close.
Spark plug fouled, faulty, or gap
too wide.
Reset gap to .030” or replace
spark plug.
See an authorized service dealer.
Poor Trimming Performance
Trimmer line too short or worn.
Worn or damaged spindle belt.