To Next PageTo Next Page
Need help?Do you have a question about the Weber Searwood and is the answer not in the manual?
General| Grate Material | Porcelain-enameled cast iron |
|---|---|
| Hopper Capacity | 20 lbs |
| Fuel Type | Pellet |
| Temperature Control | Digital |
| Warranty | 10-year limited warranty (cookbox), 3-year limited warranty (components) |
Remove internal cookbox components from the grill.
Detach the grill lid from the main body.
Unscrew and remove the burn pot.
Detach the glow plug assembly.
Remove the finger guard component.
Detach the hopper lid.
Remove the electronic controller unit.
Detach the probe hub assembly.
Open the access door for the hopper.
Remove the auger assembly.
Detach the ferrite clamp.
Remove the hopper access door.
Disconnect wiring from the circuit board.
Remove the main circuit board.
Detach the controller mounting bracket.
Remove the pellet release chute.
Detach and remove the main hopper.
Install the new hopper assembly.
Reattach the pellet release chute.
Reinstall the controller mounting bracket.
Reinstall the main circuit board.
Reinstall the hopper access door.
Reattach the ferrite clamp.
Reinstall the auger assembly.
Connect wires to the circuit board.
Connect the circuit board.
Organize and secure all wiring.
Reinstall the hopper lid.
Reinstall the finger guard.
Reinstall the controller unit.
Reinstall the probe hub assembly.
Reconnect the glow plug bracket.
Reinstall the burn pot.
Reinstall internal cookbox components.
Reattach the grill lid.
