WebWayOne WebWay IP/GPRS User Manual

WebWay IP/GPRS & WebWay GPRS/PSTN Installation Manual
WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ
Tel 01635 231514: Email support@webwayone.co.uk
Page 1
WebWayOne
WebWay IP/GPRS & WebWay GPRS/PSTN
Installation Manual
Alarm signalling & remote alarm system management
For high security signalling with EN50131-1 Grade 2, 3 & 4 I&HAS
WebWay IP/GPRS LPS I&HAS – LPCB 1022b/01
I&HAS Grade 2 – Dual Path LPS 1277 ATS5
I&HAS Grade 3 – Dual Path LPS 1277 ATS5
I&HAS Grade 4 – Dual Path LPS 1277 ATS5
Sweden + Europe SSF 114 Version 2 (alarm classes 1, 2, 3, & 4)
Norway FNH, Denmark, Finland
Belgium/Netherlands INCERT T014 + A1:2020 + A2:2003 + A3:2005
EEC EN Grade 2, 3, & 4
WebWay GPRS/PSTN LPS I&HAS – LPCB 1022b/02
I&HAS Grade 2 – Dual Path LPS 1277 ATS4PLUS
I&HAS Grade 3 – Dual Path LPS 1277 ATS4PLUS
Sweden + Europe SSF 114 Version 2 (alarm classes 1, 2 & 3)
Norway FNH, Denmark, Finland
Belgium/Netherlands INCERT T014 + A1:2020 + A2:2003 + A3:2005
EEC EN Grade 2, 3, & 4
For high security signalling with EN54-21: 2006 Fire Alarm Systems
WebWay IP/GPRS LPS Fire – LPCB 1022a/01
Fire Alarms & Fault Warning Type 1 - Dual Path LPS 1277 Fire Type 1
WebWay GPRS/PSTN LPS Fire – LPCB 1022a/02
Fire Alarms & Fault Warning Type 2 - Dual Path LPS 1277 Fire Type 2
Important – For marking and labelling requirements please refer to pages 5 and 6 of this guide.
Part number 12-0031
Issue 2D July 2 2012

WebWayOne WebWay IP/GPRS Specifications

General

Brand	WebWayOne
Model	WebWay IP/GPRS
Category	Security System
Language	English

Summary

System Description

WebWay IP/GPRS and GPRS/PSTN Overview

Explains dual path alarm signalling systems for broadband, GPRS, and PSTN.

Remote Management and Support

Equipment Part Numbers

Pre-Installation and Configuration

Fire System Installation Requirements

Details mandatory requirements for fire systems compliance with EN54.

I&HAS and Fire Signalling Configuration

Specifies configuration profiles for Intruder, Hold-up, and Fire alarm systems.

GPRS/PSTN Configuration and Notes

Covers GPRS/PSTN configuration and important installation notes.

Equipment Familiarisation

IP/GPRS and GPRS/PSTN Interface Layouts

Familiarises with the IP/GPRS and GPRS/PSTN PCB layouts and connections.

Interfaces, Controls, and Indicators

Device Interfaces and Connections

PIN Inputs, Outputs, and Power

PIN Input and Output Specifications

Details specifications for PIN inputs (EOL, tamper) and outputs.

Installation Process: Connections

Antenna and Network Connections

Guides on antenna, Ethernet, IP addressing, and firewall setup.

GPRS/PSTN Telephone Line Connection

Connecting to the Alarm System

Serial and PIN Input Connections

Modem Capture Module Installation

Modem Capture Module Usage and Setup

Configuration, Site ID, and Commissioning

Fault Output Mapping and Power Connection

Site ID Entry and Commissioning

Step-by-step guide for entering Site ID and the commissioning process.

Testing and Signal Strength Optimisation

Alarm Testing with ARC and Path Simulation

Covers testing alarms with ARC and simulating path failures via DIP switches.

Remote Servicing and Management

Remote Servicing and Automatic Testing

Remote Panel Management Procedures

Annex A & Table 11: Configuration and Performance

I&HAS Configuration Profiles

Fire Alarm Configuration Profiles and Performance

Annex B: LPS 1277 Installation Procedures

SPT Location, Protection, and Connections

Power and Network Requirements

Power Supply and Connection Details