Weda B600 - Page 2

underwater
cleaning
technology
B600 Service Manual
1. Standart equipment
2. TechnicalspecicationB600
2.1 Cleaning unit
2.2 Trolley and safety transformer
3. Installation and maintenance
3.1 Dataplate and signs
3.2 Remote control and Start Up display
3.3 On/Off Switch
4. Immersion in the pool
5. Running the cleaner
5.1 Manual and automatic mode
5.2 Vertical wall cleaning
6. Recovery from the pool
6.1 Preparation after the use
7. Adjustments
7.1 Bumper bar sensor
7.2 Bumper bar angle
7.3 Drive track tension
7.4 Drive track pressure
8. Maintenance, Service, Inspection
 8.1Shaftsealatimpeller,lubricationandremplacement
Service intervalls
 8.2Lubricationwithgreasegun
 8.3Specications
8.4 Additional inspections after 200 hours
Inspection of drive tracks
Inspection of bumper bars
8.5 Complete overhaul and service
9. Important
10. Trouble Shooting