underwater
cleaning
technology
B600 Service Manual
5.2 Vertical surface cleaning
Prepare the cleaner by moving the rubber strips (at the front and back edge ot the bottom plate)
to the lower position .
Drive the cleaner in the pool towards the wall to be cleaned.
Stop the machine with the pump motor running.
Pull the cleaner upwards with the bottomplate towards the wall .
Grab the bumper bar and let the unit sucks itself onto the wall.
Drive the unit on the wall in manual mode.
6. Recovery fron the pool
Drive the cleaner backwards against the wall to a spot near the trolley.
Lift the cleaner by the oating cable slowly up to the water level .
Keep the remote control whithin reach.
Grab the lifting rope and let the unit lean over the pool edge.
Start the unit and drive it over the edge and via the ramp onto the trolley.
Stop with the remote control.
Turn the unit o, disconnect the power supply and coil up the cables on the trolley.
Move the ramp into the driving position and unlock the trolley wheels.
Move the unit to its storage.
6.1 Preparation after use
Inspect and clean belts, impeller, brushes and wheels.
Remove the lter bags.
Flush the bags with water after turning them inside out.
Let the bags dry o.
Flush the cleaning unit with water.
To Next Page
Loading...