Weda B600 - Page 9

underwater
cleaning
technology
B600 Service Manual
8. Maintenance, Service , Inspection
8.1Shaftsealatimpeller.Lubricationandreplacement.Serviceintervals.
Cleaners used at depths not exceeding 5 m should be lubricated after 200 hours of operation.
The seal should be replaced after 1000 hours of operation.
Operation depths 5-7 m : lubricate the shaft seal after 10 hours of operation.
The seal should be replaced after 500 hours of operation.
Replacement of the seal is preferably carried out in connection with a complete overhaul.
8.2 Lubrication with grease gun.
Use only Weda Poolcleaners non toxic white grease .
Five strokes with the grease gun is sucient.
Do not overll, excessive grease will be forced out.
8.3Specications.
For grease gun : Weda Poolcleaners white non toxic special grease WP Nº 740 388.
For screw gear : oil API GL4 75W90, 100 cc WP Nº 740 209 .
8.4 Additional inspection after 200 hours
Inspection of drive tracks
Inspect the drive tracks tension
Inspection of bumper bars
Make sure that the bumper bars move in and out without jamming.
If necessary disassemble, clean the parts and reassemble.
8.5 Complete overhaul and service after 1000 hours
Contact your Weda service agent.