To Next PageTo Next Page
Need help?Do you have a question about the Weed Eater HD13538 and is the answer not in the manual?
General| Brand | Weed Eater |
|---|---|
| Model | HD13538 |
| Category | Lawn Mower |
| Language | English |
Read, understand, and follow all instructions on the machine and in the manual before starting.
Slopes are a major factor related to loss of control and tip-over accidents.
Tragic accidents can occur if the operator is not alert to the presence of children.
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
Remove all accessible loose parts and parts cartons from carton.
Assemble extension shaft and boot, then install steering wheel onto adapter.
Adjust seat before tightening adjustment bolt to ensure comfortable position.
Charge battery for minimum of one hour at 6-10 amps if needed.
Follow instructions to roll or drive tractor off skid.
Reduce tire pressure to PSI shown in "PRODUCT SPECIFICATIONS" section.
Ensure mower housing is properly leveled side-to-side and front-to-rear.
Learn and understand the meaning of symbols that may appear on your tractor.
Familiarize yourself with the locations of various controls and adjustments.
Depress clutch/brake pedal and place parking brake lever in "ENGAGED" position.
Allows operation of mower deck or other powered attachment while in reverse.
Warning: Do not drive up or down hills with slopes greater than 15 degrees.
Fill in dates as you complete regular service intervals.
Key checks before each use and general maintenance recommendations.
Includes checking oil, cleaning filters, and replacing plugs.
Procedures for sharpening, removing, and replacing mower blades.
Procedures for removing, installing, and leveling the mower deck.
Check and adjust the brake system for proper stopping distance.
Instructions for replacing mower blade drive and motion drive belts.
Steps for safely disconnecting and replacing the tractor battery.
Procedures for preparing the tractor for storage.
Important steps to prevent gum deposits and ensure fuel system health.
Common causes and corrections for engine starting issues.
Troubleshooting uneven cuts, blades not rotating, and poor discharge.
Diagnosing issues with headlights, battery charging, and engine shutdown.
