EasyManua.ls Logo

WeeRide CoPilot - Weather and Visibility Precautions; Night Riding and Hazard Avoidance; Assembly and Preparation

WeeRide CoPilot
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RULES OF THE ROAD continued
4. CAUTION: WET WEATHER WARNING: Check your brakes frequently. The ability to stop is critical. Roads are slippery in wet
other debris on the road can also affect stopping distance. If at all possible, do not ride in wet weather. Vision and control are impaired,
creating a greater risk of accidents and injury.
5. CAUTION
that restricts your vision or your hearing.
6. When riding, ALWAYS WEAR AN APPROVED BIKE HELMET
your bike.
9. Never carry passengers. This is dangerous and it makes the bicycle harder to control. Never carry packages that can hinder your vision
or control of the bike.
10. When riding in pairs or in larger groups, form a single line along the right side of the road. Set up a sensible distance between riders.
Don’t follow too closely.
11. Always be alert. Animals or people may dart in front of you. Give pedestrians the right-of-way. Don’t ride too close to pedestrians, and
12. Be careful at all crossroads. Slow down and look both ways before crossing.
13. Use hand signals. Always let other drivers and pedestrians know what you are going to do. Signal 100 ft. before turning unless your
hand is needed to control the bike.
Observe all local traffic
14. WARNING: NIGHT TIME OPERATION: We do NOT recommend riding your bike at night. If you have an emergency that
15. Cover your stem, handlebar, and top tube with safety pads for additional protection.
16. Never hitch rides. Never hold onto moving vehicles while riding. Never stunt ride or jump on your bike.
17. ON AND OFF ROAD OPERATION: Avoid the following road hazards: drain grates, pot holes, ruts, soft road edges, gravel, leaves
(especially when they are wet), uneven pavement, railroad crossings, manhole covers, curbs, speed bumps, puddles, and debris call all
have effect on your riding and result in loss of control.
18. Do not ride your bicycle if the chain cover is not attached.
BEFORE RIDING:
Your new bicycle was assembled and tuned in the factory and then partially disassembled for shipping. The following instructions will
enable you to prepare your bicycle for years of enjoyable cycling. For more details on inspection, lubrication, maintenance and adjustment
of any area please refer to the relevant sections in this manual. If you have questions about your ability to properly assemble this bicycle,
please consult a professional bicycle mechanic before riding.
TO AVOID INJURY, THIS PRODUCT MUST BE PROPERLY ASSEMBLED BEFORE USE. WE
STRONGLY RECOMMEND THAT YOU REVIEW THE COMPLETE ASSEMBLY GUIDE AND
PERFORM CHECKS SPECIFIED IN THE OWNER’S MANUAL BEFORE RIDING.
• 5/6mm hex wrench
Torque wrench
• Bicycle lubricant or grease
• 6” adjustable wrench
• Phillips & standard screwdrivers
A pair of pliers with cable cutting ability