Wega P700 - Page 12

MAINTENANCE
Stylus
Before playing, clean the stylus using a soft brush. Brush the
stylus from back to front. Never attempt to clean the stylus with
finger tip. If fluid-type stylus cleaner is used, make sure not to
moisten the stylus too much.
Cabinet
Clean the cabinet and dust cover periodically with a soft dry
cloth. If the stains are difficult to remove, use a cloth moistened
with a mild detergent solution. Do not use solvents such as
alcohol, benzine or thinner, since they will damage the finish.
Rubber mat
When the rubber mat becomes dirty, wipe it gently with a soft cloth
slightly dampened with water.
Lubrication
No lubrication is required for this turntable. The motor shaft is
factory lubricated for the life of the turntable.
12
SPECIFICATIONS
Turntable
Platter 31 cm (1244 in.), aluminum-alloy diecast
Motor Linear BSL (brushless and slotless) motor
Direct drive
Crystal lock control, magnedisc servo
control system
Speed 334/3 rpm, 45 rpm
Starting characteristics Comes to nominal speed within a
half revolution (334/3 rpm)
0.02% (WRMS)*, 0.025% (WRMS)
+0.04% (DIN)
Signal-to-noise ratio 78 dB (DIN-B)
Load characteristics 0% up to 100 g stylus force (at lead-in
groove of a record)
Within +0.003%
Lead-in, return, reject, repeat,
Drive system
Control system
Wow and flutter
Speed deviation
Automatic system
Tonearm
Type Statically balanced, universal
Pivot-to-stylus length 216.5 mm (84/2 in.)
Overall arm length 300 mm (117/s in.)
Overhang 16.5 mm (21/32 in.)
Tracking error (+) 3° -(-) 1°
Stylus force adjustment range 0O-3g
Cartridge shell weight 11.59
Cartridge weight range (including supplied shell)
13- 20.59
19 - 26.5 g (with extra weight)
Cartridge
Type Moving-magnet
Frequency response 10 - 30,000 Hz
Channel separation 25 dB at 1 kHz
Output voltage 4mV at 1 kHz, 5 cm/sec, 45°
Load impedance 50 k ohms - 100 k ohms
Tracking force 1.2 - 2.5 g (1.7 g recommended)
Stylus ND-15G
Weight 5.29
General
Power requirements 220 V ac, 50/60 Hz
Power consumption 12W
Dimensions Approx. 430 x 135 x 375 mm (w/hi/d)
(17 x 53/a x 143/4 in.)
including projecting parts and controls
Weight Approx. 7 kg (15 Ibs 7 oz), net
Approx. 8.6 kg (19 Ibs), in shipping
carton
Supplied accessories
45-rpm adaptor (1)
Extra weight (1)
Cartridge (1)
Cartridge shell (1)
Design and specifications subject to change without notice.
* This new measuring method concerns only the turntable assembly, in-
cluding the platter. !t excludes wow and flutter caused by the tonearm, the
cartridge, or the record. Measured by obtaining signal from magnetic pick-
up head. ‘