Weider WESY19611 - Page 16

15
15
16
4
12
27
21
15
37. Identify the Resistance Cable (27). Thread the
1/2” Plain Nut (101) onto the bolt at the end of the
Resistance Cable (27). Thread the Resistance
Cable part way into the lower end of the Weight
Tube (63). Tighten the Plane Nut against the
Weight Tube.
38. Wrap the Resistance Cable (27) around a 3 1/2”
Pulley (15). Attach the Pulley inside of the indicat-
ed bracket on the Base (4) with a 3/8” x 2” Bolt
(12) and a 3/8” Nylon Locknut (21).
39. Wrap the Resistance Cable (27) up around a 3 1/2”
Pulley (15). Attach the Pulley and a Cable Trap
(66) to the 3/8” x 3 1/2” Bolt (16) in the Base (4)
with a 3/8” Nylon Locknut (21).
40. Wrap the Resistance Cable (27) around a 3 1/2”
Pulley (15). Attach the Pulley and another 3 1/2”
Pulley (15) inside of the wide bracket on the Base
(4) with a 3/8” x 3” Grade 5 Bolt (98) as shown.
Do not attach a Nylon Jamnut (not shown) yet.
37
38
39
40
66
16
4
27
21
15
98
4
27
27
101
63