Copyright © 2013 Weidmüller Interface GmbH & Co. KG 8 / 103
All rights reserved. Reproduction without permission is prohibited.
DIN-rail mounting:
Insert the top of the DIN-rail clip behind the upper edge of the DIN-
rail (1). Then open the latch at bottom of the device by using a flat-
bladed screwdriver and fix the device on the DIN-rail by gently
pressing on the bottom (2).
To remove the Router from the DIN-Rail, simply reverse the steps
as described above.
5. Technical data
Static or dynamic routing according to
RIPv2 or OSPF protocol
2-Port-Switch with additional Layer-2 fil-
ter
DHCP Server / DHCP Relay
DNS-Relay
NTP-Client
DynDNS (DHCP-Client nach RFC 2136)
IPv4 Stateful inspection Firewall
NAT-Masquerading, 1:1 NAT,
Portforwarding
Layer-2/3-Filter (VLAN ID, VLAN QoS
Tag, MAC adddress based, Ethertype
Frame)
"Auto-Learning"-function to create new
packet filter rules (Analysis of the net-
work traffic)
Layer 2/3 packet priorizitation (Ethernet
Frame, IP Header, VLAN Tag)
Configurable as OpenVPN server or cli-
ent (Layer 2 and Layer 3)
Authentication with X.509 Certificates
Tunnel support via HTTP-Proxy
A maximum of 10 different server con-
figurations
Unlimited number of client connections in
server mode
To Next Page
Loading...