To Next Page
D
Daniel DixonAug 3, 2025
How to reset Weishaupt W-FM 100 burner after a fault?
- BBarbara Roy MDAug 3, 2025
To reset the burner after a fault, press the reset key. The burner should then be reset.
How to reset Weishaupt W-FM 100 burner after a fault?
To reset the burner after a fault, press the reset key. The burner should then be reset.
What to do if the ABE displays a fault in Weishaupt W-FM 100?
If the ABE displays a fault, try the following: * Exit the display using the [esc] key. * Reset the burner using the [ENTER] key. If the [esc] key has been pressed twice, the reset can only be carried out via the menu. To do this: 1. Select 'Operating display'. 2. Select 'Status/Reset'. The current lockout will be displayed. You can then exit the display using the [esc] key and reset the burner using the [ENTER] key.
Immediate actions to take when gas is detected.
Instructions for connecting the combustion manager, including safety warnings.
Covers the O2 controller functionality for modulating burners with O2 module.
Covers the CO monitor and CO controller functions, requiring O2 trim.
Describes the PID load controller functionality.
Covers the FGR function, its modes, and settings.
Covers burner adjustment procedures.
Describes configuring the load controller.
Covers setting O2 monitor and defining fuel type.
Covers setting the measurement amplifier LT3 and CO control parameters.
Guides on adjusting FGR for temperature compensation.
Covers determining excess air, flue gas temperature, and flue gas losses.
Covers checking prerequisites and handling faults/lockouts.
Describes fault occurrences, shutdown behavior, and accessing fault history.
Explains lockout conditions, display, and reset procedures.
General| Brand | Weishaupt |
|---|---|
| Model | W-FM 100 |
| Category | Controller |
| Language | English |
