Need help?Do you have a question about the weistek IdeaWerk and is the answer not in the manual?
General| Build Volume | 150 x 150 x 140 mm |
|---|---|
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Bed Leveling | Manual |
| Connectivity | USB, SD Card |
| Power Supply | 110V/220V, 50/60Hz |
| Supported Materials | PLA, ABS |
| Print Technology | FDM (Fused Deposition Modeling) |
| Display | LCD |
Verify the printer and its accessories are present and undamaged upon unboxing.
Inspect all included accessories to ensure they are present and in good condition.
Essential safety guidelines and precautions for operating the Ideawerk 3D printer.
Identification of key components and structural parts of the Ideawerk printer.
Detailed technical specifications of the Ideawerk 3D printer, including dimensions and capabilities.
Steps to disable driver signature enforcement on Windows 8/8.1 for driver installation.
Guide for installing the necessary drivers for the Ideawerk on Windows 8 and 8.1.
Procedure to confirm successful installation of drivers on Windows 7, 8, and 8.1.
How to run the Ideawerk software as an administrator on Windows 7, 8, and 8.1.
Instructions for installing drivers on Windows XP operating system.
Steps to disable sleep mode on Windows 7, 8, and 8.1 to prevent printing interruptions.
Guide to calibrating the building plate and setting the Z-height for optimal printing.
How to set the target temperature for the extruder before printing.
Instructions on how to properly load filament into the Ideawerk printer.
Procedure for replacing filament when it runs out or needs changing.
Steps to reverse the filament, typically for removal or troubleshooting.
Overview of the various functions and interface elements of the DoraWare software.
How to configure print parameters like base, support, infill, shells, and speed.
Steps to generate the Gcode file required for the 3D printer to execute a print.
Instructions on how to initiate the printing process, both online and offline.
Procedures for removing the finished print and preparing for the next job.
Solutions for resolving extruder blockage issues and cleaning the nozzle.
To Next Page
