Welch Allyn AED 10 - Electrical Energy and ECG Misinterpretation Warnings

Operating Instructions 11
Allows the Instructor to select
AHA Scenario number 3 as the
default scenario. The Trainer will
automatically turn off after the
selection has been made.
Allows the Instructor to select
AHA Scenario number 4 as the
default scenario. The Trainer will
automatically turn off after the
selection has been made.
Allows the Instructor to select
AHA Scenario number 5 as the
default scenario. The Trainer will
automatically turn off after the
selection has been made.
Allows the Instructor to select
AHA Scenario number 6 as the
default scenario. The Trainer will
automatically turn off after the
selection has been made.
Allows the Instructor to select
AHA Scenario number 7 as the
default scenario. The Trainer will
automatically turn off after the
selection has been made.
Allows the Instructor to select
AHA Scenario number 8 as the
default scenario. The Trainer will
automatically turn off after the
selection has been made.
1-Shock Protocols
Allows the Instructor to select
Ventricular Fibrillation with one-
shock conversion. The Trainer will
automatically turn off after the
selection has been made.
Allows the Instructor to select
Ventricular Fibrillation with one-
shock conversion followed by
refibrillation. The Trainer will
automatically turn off after the
selection has been made.
Note: Scenarios 11 and 12 are not accessible through remote control, and must be
accessed through the Scenario Menu.
Current Scenario Shock Protocols
Allows the Instructor to interrupt
any scenario with a continuous
shockable rhythm. The current
default scenario is not changed.
Allows the Instructor to interrupt
any scenario with a continuous
non-shockable rhythm. The
current default scenario is not
changed.
Other Functions
Allows the Instructor to interrupt
any scenario with a lead-fault
condition. To resume the
scenario, press the button again.
Allows the Instructor to interrupt
any scenario with a “Motion”
condition on the next rhythm
analysis.
Allows the Instructor to interrupt
any scenario with a Low Battery
condition. To resume the
scenario, press the button again.
Allows the Instructor to simulate
a Warning (flashing icon) system
status. To resume the scenario,
press the button again.
Allows the Instructor to pause
during any scenario. To resume
the scenario, press the button
again.
While the Trainer is paused, all
other buttons are inactive until the
pause button has been pressed
again.
Table 3. Remote Control Buttons (continued)
3
4
5
6
7
8
9
10