INDEX: FAILURE / CAUSE
LS200 MECHANICAL
COMPLAINT / (CONDITION): CAUSE / CORRECTIVE ACTION:
__________________________ _____________________________
Light head wobbles. ..... clear plastic cover on front of light head is not put
on properly. REFER to lamp replacement
instructions to VERIFY that plastic cover tabs are
aligned with those on the white plastic light housing.
REMOVE and RE-INSTALL clear plastic cover.
Power supply wobbles. ..... power supply attachment points are not secure.
TIGHTEN this connection by PUSHING the power
supply housing down onto the mounting screws as
far as it will go.
Mobile stand is difficult ..... casters are locked. UNLOCK casters when moving unit.
to move.
..... wheel(s) are bound up with foreign material such as
string. CLEAR obstruction.
LS200 is noisy ..... some type of cleaning agent or solvent may have
when articulated. gotten into joint(s). ALLOW it to dry and DO NOT
LUBRICATE.
..... foreign material has built up in the joint. WIPE
material out of joints.
..... the heat shrink tubing over the spring is not in
place. REPOSITION to eliminate sound.
LS200 makes clicking sound ..... strap attached to spring is interfering with mandrel
when upper arm is raised assembly. Replace strap and any other worn parts in
and/or lowered joint #3. REASSEMBLE according to instructions
in section K.
END LS200 MECHANICAL TROUBLESHOOTING
T E C H N I C I A N N O T E S :
____________________________________________________________________________
____________________________________________________________________________
11
To Next Page
Loading...
Need help?
General
