APPENDIX CC
The following items or their equivalent are required for the complete repair and testing of the LS200
Halogen Light:
COMMON TOOLS:
Item: Description:
1. Screwdriver: Phillips #1
2. Screwdriver: Phillips #2
3. Screwdriver: 7/32" 5.5mm Flat Blade
4. Strain relief tool HEYCO no.29
5. Pliers, long nose: Xcelite 51CG
6. Pliers, crimping: Klein 1005
7. Pliers, slip joint, Channel Lock # 420
8. Wire cutter: Xcelite 107CG
9. Wire stripper: Xcelite 105SCG
10. Hex key set
11. Volt-Ohm Meter (with input impedance
above 1 megohm) EX.BECKMAN 330
12. Alligator test leads kit
13. Open end wrench,15/60 degree 15/16"
14 Heat shrink gun.
15. 3/8" Nut driver
SPECIAL WELCH ALLYN TOOLS:
ITEM:
1. Spring tensioning tool T-12686
2. Chatillion gage T-7047-2
3. Holding fixture for arm and
Support fixture for Luminaire T-13403
4. Front transformer housing nest T-12930
5. Tinnerman clip tool T-12643
6. Two degree tilt universal
connector fixture T-13414
MATERIALS:
ITEM: DESCRIPTION: W/A Part #:
1. Loctite #242 M30338
USED ON PIVOT NUT INSIDE LUMINAIRE
2 Loctite #222 M30375
USED ON LONG ARM SET SCREW
3. Loctite #403 M30372
4. Loctite Primer #770 M30391
ITEMS 3 AND 4 USED ON JOINT #3, MAIN HINGE.
5. Dow Corning #7 release compound M11175
USED ON CONTACT SURFACES BETWEEN
YOKE AND LUMINAIRE.
42
To Next Page
Loading...
