Welch Allyn SureTemp 4 - Page 14

Mode Table
Toggle Between
°F or °C Setting
While temperature is
displayed, with probe in
or out of storage channel
Press Mode
button. Release
within 2 seconds
Monitor Mode
Remove probe from
storage channel
Press Mode
button for more
than 2 seconds
Temperature
Recall
Place probe in
storage channel
Press and
release mode
button
Step 1
Step 2
Feature
Instrument Malfunction: If this icon is displayed,
record error code shown on the display and contact
the Diatek Customer Service Department.
Broken Probe: If flashing, probe has been damaged.
Remove and reinstall probe. If error persists, then
install a new probe.
Probe Position: Probe has broken contact with the
tissue. Once proper contact has been achieved, the
icon will be turned off but will reappear at the end of
the temperature measurement. It is recommended
that a new temperature be taken.
10