WELLSYS HOT & COLD WATER PURIFIER
- It is recommended to change filters as indicated to enjoy clean, fresh water.
- The filter replacement cycle does not indicate the quality warranty period, but indicates the
ideal period for filter replacement.
- The replacement cycle may be shorter depending on the water quality, water pressure,
temperature and usage
- It is suggested to install a pump to increase the water quantity and flow if the source water
pressure is below 42psi.
10. Replacement cycle of filters and
filter replacement procedures
8. Features of WELLSYS hot & cold
water purifier
9. Identifyung the parts
2) how to replace filters
1. Turn off the tap water, and unplug the unit.
2. Pull down and forward the front panel
3. Remove the filters by disconnecting from the fittings,
and replace with new filters.
It is important that the filters are flushed prior to
utilization in the cooler.
④ from the unit.
4. Return the front panel on the unit.
5. Turn on the tap water, and then plug in the unit.
ⓐcollet
fitting
filter
10
WELLSYS HOT & COLD WATER PURIFIER
WELLSYS HOT & COLD WATER PURIFIER
11
1) Modern state of the art design
2) LED power lights
3) LED lights for easy operation of cold and hot water
4) Optional cold control with either one hand dispense of one button control
5) The hot and cold water can easily be turned on or off individually.
6) The unit can be set for 5 levels of hot water, and 3 levels of cold water.
7) The unit has a safety device for hot water.
1) Replacement cycle of filters
elcyctnemecalperretlfipets
1st
12 months
12 months
36~60 months or high TDS
36~60 months
24~36 months or when change RO
12 months
enarbmemOR3
UF membrane
PH filter
ht4
ht5
⑤hot water spigot
③hot water safety button
with LED lamp for
hot water
①hot water button
④front panel
②cold water button
⑥cold water spigot
⑦LED lamp and button for
cold water
3rd(optional)
ELITE 9000
WELLSYS HOT & COLD WATER
To Next Page
Loading...