To Next PageTo Next PageHow to fix WELLSYSTEM RELAX when there is no power supply?
First, check if the mains plug of your WELLSYSTEM Massager is properly connected to the mains socket and ensure that the fuse or cut-out is switched on. If the issue persists, it is recommended to contact customer service for further assistance.
What to do if WELLSYSTEM Massager water temperature is too high?
If the water temperature of your WELLSYSTEM Massager is too high (above 45°C), reduce the pressure or switch off the unit. If you have a cooling system, ensure the water tap is open and the water shut-off valve is not activated. Also, inspect the supply and drainage lines for any kinks. If problems persist, contact customer service.
What to do if WELLSYSTEM RELAX Massager shows chip-card reading error?
If you are getting a reading error with the chip-card in your WELLSYSTEM Massager, ensure that the card is inserted correctly. If the problem continues, try using a different, known valid card.
What to do if WELLSYSTEM Massager says chip-card is invalid?
If your WELLSYSTEM Massager indicates that the chip-card was inserted incorrectly or is no longer valid, first, ensure that the card is correctly inserted. If the issue persists, try using a valid card.
General| Brand | WELLSYSTEM |
|---|---|
| Model | RELAX |
| Category | Massager |
| Language | English |
