www.Welltec.pro 12
Press „SLEEP” button on the panel to turn on. If the air conditioner is
in cooling mode, the unit will raise the target temperature by 1 ℃
after one hour. After two hours, the temperature will increase by a
maximum of 2 ℃.
In heating mode, the air conditioner will lower the target temperature
by 1 ℃ after one hour of operation. After two hours, the temperature
will drop by a maximum of 2 ℃.
When the machine's water tank is full, the display will show error code
E4. In this case, empty the tank by connecting the drain tube to the
bottom drain hole.
When the unit is started up in low temperature, it will be defrosted
first. The code dF is then shown on the control panel display.
There are also markings on the air outlet on the control panel.
• Connect an exhaust air pipe to the warm air outlet when the air
conditioner is in cooling mode.
• Connect an exhaust air pipe to the cold air outlet when the air
conditioner is operating in heating mode.
Hold down the function button for 5 seconds with the device turned off to change the
display mode to Celsius (℃) or Fahrenheit (℉).
To Next Page
Loading...
