- 7 -
Note:
With the alarm function “CD”, in addition to the
indicator ON/OFF
1(, the indicator REPEAT 2! will
also glow. The automatically activated repeat function
will ensure that the alarm can sound for a full hour,
even with CDs having a shorter programme.
7. To stop the alarm, press the button “ALARM 1”
r. The indicator ON/OFF 1( extinguishes, but
the indicator ALM. 1
1& continues to glow, so
that the alarm can sound again on the following
day. If you do not wish this, and want to switch
the alarm function off, press the button "ALARM
1"
r once more.
Entering alarm time 2
The programming of alarm time 2 is identical to the
programming of alarm time 1. Instead of pressing the
button “ALARM 1”
r press the button "ALARM 2" t
and orientate on the display ALM. 2
2%.
The snooze function
Should you wish to snooze for an extra six minutes
after the alarm goes off, press the button SNOOZE
1). On expiration of the six minutes the appliance
switches itself back on. You can activate the snooze
repeatedly until the maximum alarm time (60
minutes) has expired.
The sleep function
You can fall asleep with the accompaniment of a CD
or a radio station - the appliance switches off at the
time you have programmed in.
1. With the function switch (FUNCTION
1%) select
the preferred operational mode.
2. Press the button SLEEP
y. The indicator ON/
OFF
1( glows and the display 2$ shows "90".
This indicates that the appliance will switch itself
off automatically after 90 minutes.
3. To reduce this running time to 60, 30 or 15
minutes, press correspondingly on the button
SLEEP
y. The selected time value is shown for
two seconds in the display.
4. Press the button SLEEP
y once more and the
appliance will set the running time back to 90
minutes.
5. To prematurely end the sleep automatic, press
the button ON/OF
q.
AUX Operation
You can connect an external audio source to the
radio, such as an MP3 Player or similar.
1. Connect the Line audio output or the headphone
output of the preferred appliance, via a shielded
cable fitted with a 3.5mm jack plug, to the AUX-
Input
2( at the rear of the appliance.
2. The positioning of the function switch
(FUNCTION
1%) is not important here. As
soon as this connection is made, the appliance
deactivates the radio and CD elements. Only the
signal at the AUX-Input will be played back.
3. Start playback on the connected appliance,
regulate the sound level with the volume
regulator (VOLUME
2*).
Cleaning and Care
Attention!
When you have withdrawn the plug from the wall •
power socket you can clean the housing with a
soft dry cloth. Do not use agressive detergents!
Do not permit fluids to permeate into the interior •
of the appliance. This would cause irreparable
damage to the appliance.
Do not use moist cloths or anything similar.•
Troubleshooting
No or poor radio reception
Check to ensure that the VHF wire aerial > 3! is
unwound and optimally aligned.
If need be, slide the switch BAND >
1^ from
the position FM ST. to the position FM, so
that the appliance can also receive weaker
transmissions.
Change the position and alignment of the CD >
Clock Radio until you get a better reception of
MW transmitters.
To Next Page
Loading...