Symbols on the product
Warning
Read this manual
Use approved head protection,
hearing protection and eye
protection
Use approved protective gloves
The product agrees with the
applicable EC Directives
Chain brake, not engaged (left).
Chain brake, engaged (right)
Refueling
This product agrees with the
applicable EAC directives
This product agrees with the
applicable Ukraine directives
Hold the product properly with
both hands
Do not use with one hand
Avoid contact with nose of guide
bar
Beware of kickback
Note: Other symbols/decals on the product
commercial areas.
Product liability
As referred to in the product liability laws, we
are not liable for damages that our product
causes if:
the product is incorrectly repaired.
the product is repaired with parts that are
not from the manufacturer or not approved
by the manufacturer.
3
Useful information
Wear dense texture clothes
and rugged footwear with
non-slip soles
Prohibited
It is forbidden to be in the
danger zone
Sym Meaning
Do not use the product in
bad weather
on your product.
1. Make sure that the saw chain is correctly
tensioned. A slack chain will move
sharpen correctly.
2.
cutting teeth from the inside face and
reduce the pressure on the return stroke.
3.
the other side.
4. File all the teeth to the same length. When
the length of the cutting teeth is reduced to
4 mm (5/32") the saw chain is worn out and
must be replaced.
A
To adjust the depth gauge setting
Sharpen the cutting teeth before you adjust
the depth gauge setting. See
To sharpen the
cutting teeth on page 25
. When you sharpen
the cutting tooth (A), the depth gauge setting
(C) will decrease. To maintain optimal cutting
performance, the depth gauge (B) has to be
gauge setting.
A
B
C
Note: This recommendation assumes that the
length of the cutting teeth is not reduced
excessively.
the depth gauge.
1. Put the depth gauge tool above the saw
chain. Detailed information regarding how
to use the depth gauge tool will be found
on the package of the depth gauge tool.
2.
gauge that protrudes through the depth
gauge tool. The depth gauge setting is
correct when you no longer feel resistance
tool.
2
6
To sharpen the cutting teeth
the cutting teeth.
information on the recommended dimension of
To Next Page
Loading...