7
• In poorly ventilated or narrow spaces.
• Near devices that produce a strong magnetic eld.
• In direct sunlight.
• Close to a re alarm.
• In extremely hot, cold or humid environments.
Safety Precautions
- Do not place this projector on an unstable platform, stand or table so as to prevent it from falling and causing serious
damage or personal injury.
- Do not look directly into the lens when the projector is turned on to avoid eye damage.
- Do not attempt to disassemble this projector as it may contain dangerous high voltage components. This projector
must only be maintained and repaired by a qualied or authorized technician.
- Do not place this projector in an upright position, as it may fall over and cause injury or damage.
- Do not expose this projector to rain or moisture (operating humidity is 20%–80%).
- Do not immerse this projector in, nor expose it to water or other liquids. Immediately unplug the projector if any liquid
or object got into its housing, and have it checked by a qualied technician before using it again.
- Do not place this projector in any of the following environments:
- If you use an extension cord, it must not have a current rating lower than the projector's original power cord. Failure to
heed this warning may result in the extension cord overheating and could pose hazards such as electric shock and re.
- To avoid damage caused by a power surge or lightning strike, unplug the projector from the power outlet during
thunderstorms or when it is not in use for a long time.
- Do not place any ammable objects near this projector so as to avoid re.
- Do not block the lens with any object when the projector is turned on. Any object placed close to the lens may get very
hot and/or deformed, and may even cause a re.
- Do not block any of the vents of the projector, as this may cause a buildup of heat within the product and result in a re.
To Next Page
Loading...