INSTRUCTION MANUAL
Parallel
Connection Port
Wires
OPERATION
CONNECTING TWO INVERTER GENERATORS
1. Place your parallel kit on a dry surface, such as dry ground
or the top of your generator.
2. The parallel kit has two sets of wires. Securely connect each
set of wires to each generator’s control panel. See Fig. 1.
• Insert the red plug into the red parallel connection port and
the black plug into the black port of each generator. If the
wires are not connected correctly, the generators will not out-
put any power.
• Attach the green wire with metal ring to each generators’s
grounding nut. NOTE: Failure to properly ground the generator
or parallel kit can increase your risk of electric shock.
3. Once all the wires are correctly connected, start the inverter
generators one at a time, according to the instructions includ-
ed with your generator. The generator that has been started
first will be the primary generator.
4. Allow the generators to run for several minutes to stabilize
speed and output before plugging in your electrical device(s).
STORAGE
When the parallel kit is not in use, disconnect the kit from the inverters. Bind the cords around the parallel
kit body. Place the parallel kit back into its packaging for storage. Store in a well-ventilated, dry area.
If the parallel kit is to be left with the inverter, bind the cords together so as to prevent trampling of the plugs
and cords.
DISPOSAL
When the product reaches the end of its lifetime, please do not dispose of parts with your household waste.
This product contains components that should be recycled. Please take this product to your local recy-
cling facility for responsible disposal to minimize its environmental impact.
Fig. 1
NOTE: The total rated power of your parallel kit is 3600W (30A). Do not overload the receptacles.
WARNING! If the parallel kit is
placed on the ground, be careful not to
accidentally trample the wires.
WARNING! Make sure both
generators are OFF and all electronic
devices are unplugged from the
generator and parallel connection
kit before plugging in your kit to the
generators.
WARNING! Only use the parallel kit when plugged into
two generators. Never use parallel kit when plugged into
generator on only one end.
INSTRUCTION MANUAL
NO. PART NO. DESCRIPTION QTY.
1 GNA36i-001 Bolt, M4×50 4
2 GNA36i-002 Parallel Kit Panel Assembly with Cable 1
3 GNA36i-003 Self-tappling Screw, ST4.2×10 2
4 GNA36i-004 Front Outer Shell 1
5 GNA36i-005 Waterproof Strips 1
6 GNA36i-006 Back Outer Shell 1
7 GNA36i-007 Cable Stress Relief 2
8 GNA36i-008 Back Cover Plate 1
9 GNA36i-009 TT-30R Socket 1
10 GNA36i-010 L5-30R Socket 1
HAVE PRODUCT QUESTIONS? NEED TECHNICAL SUPPORT? Please feel free to contact us:
TECHSUPPORT@WENPRODUCTS.COM1-800-232-1195 (M-F 8AM-5PM CST)
Replacement parts and the most up-to-date instruction manuals can be found on wenproducts.com.
To Previous Page
Loading...
Need help?
General
