7
10. From the top outside edge of one Upright Tube, measure down 51¾” (131.5 cm) and mark
the location.
Align the top edge of the Retrofit Bracket with this mark and check to be sure that the
slotted holes are centered on the top half of the Hinge.
11. At this location, attach the Retrofit Bracket to the Upright Tube using three ¼-20 x 1”
Self Drilling Screws.
12. Attach the Retrofit Bracket to the Middle Panel using two Flange Bearings and two Rivets.
Be sure that the Flange Bearing is flush with the Hinge.
Using the slotted holes of Retrofit Bracket as a template, drill two ¼” diameter holes through the
top half of the Hinge and into the rear of the Middle Panel to accept the Rivet.
IMPORTANT: Only drill into the Middle Panel, do not drill all of the way through it.
The ¼” hole should be horizontally centered in the slots and vertically centered on the Hinge.
This should locate the Rivets in the upper half of the slots. If not, reposition the Retrofit Bracket
on the Upright Tube.
13. Repeat steps 10-12 to mount the remaining Retrofit Bracket to the other Upright Tube.
2%/
<:
#,
2%/
%20.&)2
0!#*%2
;6:
%+&0)++)-'
#0%51
+!-'%
%!0)-'1
)4%21
To Next Page
Loading...
