Werner QUICKCLICK - User Manual

OPERATING INSTRUCTIONS
FOR WERNER QUICKCLICK™ LADDER LEVELER
WWAARRNNIINNGG::
Failure to comply with all instructions may result in serious injury.
Operating Instructions
USER TIPS FOR PK70
READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING WORK.
IF YOU DON'T UNDERSTAND CALL 724-588-8600 FOR ASSISTANCE.
Before each use: Check that the leveler is assembled to ladder correctly and is in good working order. Make
sure the safety lock is working properly. Inspect for damaged parts. Never use or repair a damaged leveler.
Destroy the leveler if exposed to fire or chemicals. Keep your leveler clean and free from foreign material such as
wet paint, mud, grease, snow, oil, sand, etc.
W
arnings:
Do not use the leveler to support ladder in horizontal position. Do not use both levelers in fully
extended position to gain additional height.
1. Follow the instructions supplied with your ladder and always use your ladder
only at the proper 75-1/2 degree angle.
2. To adjust QuickClick™ Levelers on uneven terrain, flip the lower foot pedal
out, then press down with your foot (see Figure 1). This will extend the leg
down to the bearing surface, and activate the automatic safety lock.
3. To move the ladder to another location, simply remove all weight from the
extended leg by pulling the ladder rail towards you while keeping the ladder
in a rested position. (This disengages the automatic safety lock.) Next,
depress the upper (smaller) pedal with the ball of your foot or your thumb to
release the locking mechanism (see Figure 2). Finally, apply downward
pressure on the release lever; the leg will smoothly retract upward to the
starting position. Move the ladder and repeat Steps 1 and 2 to set it up in
another location.
Figure 1
Figure 2
A.
Always
k
eep the Quic
kClic
k
™ ladder leveler in its retracted
position when moving a ladder. This will make each
leveling operation much simpler.
B.
Always
lean the ladder at the proper angle of 75-1⁄2 deg
rees
against a solid surface to act as an upper ladder support
before extending the leveler. This will enable you to maintain
a proper balance while using y
our f
oot to e
xtend the le
v
eler
downward.
C.
Al
ways k
eep the ladder at the proper angle of 75-1⁄2
degrees and resting in its supported position (at both upper
and lower ends) while retracting the leveler. This enables you
to maintain your balance while keeping the ladder stationary
until you retract the leveler with your foot or hand.
WERNER CO., 93 WERNER ROAD, GREENVILLE, P
A 16125-9499
PHONE (724) 588-8600
www.wernerladder.com
P/N 64386-01 ©2005 W
e
r
ner Co. October 2005

Summary

Operating Instructions for Werner QuickClick Ladder Leveler

General Safety and Pre-Use Checks

Ensure leveler is assembled correctly, check safety lock, inspect for damage, and keep clean. Avoid fire/chemicals.

Usage Warnings

Do not use the leveler in a horizontal position or both levelers in the fully extended position.

Operating Instructions

Ladder Angle and Initial Setup

Follow ladder instructions and use only at the proper 75-1/2 degree angle.

Adjusting Levelers on Uneven Terrain

Extend leg using foot pedal to bearing surface and activate the automatic safety lock.

Moving the Ladder

Disengage lock, release mechanism with foot/thumb, and smoothly retract leg to move ladder.

User Tips for PK70

Retracted Position During Movement

Keep leveler retracted when moving ladder for simpler leveling operations.

Ladder Angle for Extension

Lean ladder at 75-1/2 degrees against a solid surface before extending the leveler.

Ladder Angle During Retraction

Maintain 75-1/2 degree angle during retraction for balance and stability.

Werner QUICKCLICK Specifications