EasyManua.ls Logo

Wesco asador 86 - User Manual

Wesco asador 86
33 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...

Table of Contents

Questions and Answers

  • M
    Megan AdkinsAug 13, 2025
    What to do if there is a grease fire on my Wesco Grill?
    • E
      Elizabeth WhiteAug 13, 2025
      If you experience a grease fire or continuous excessive flames above the cooking surface of your Wesco Grill, immediately turn off the control knobs and the gas cylinder valve. Leave the lid open to allow the flames to die down. Once the grill has cooled, clean any food particles and excess grease from inside the firebox area, grease tray, and other surfaces. This is due to too much grease buildup in the burner area.
  • E
    Elizabeth JacksonAug 17, 2025
    How to fix Wesco Grill burner that won't light with igniter?
    • R
      Richard WaltersAug 17, 2025
      If the burner(s) on your Wesco Grill won't light using the igniter, there could be several reasons: * Ensure the valves are positioned inside the burner tubes. * Make sure the burner tubes are not obstructed by spider webs or other matter. * Verify the gas cylinder is not empty. * Turn off knobs and disconnect coupling nut from gas cylinder. Reconnect and retry. * Turn the coupling nut approximately one-half to three-quarters additional turn until solid stop. Tighten by hand only - do not use tools. These issues can arise from trying to light the wrong burner (refer to Section 7 for lighting instructions), the burner not being engaged with the control valve, an obstruction in the burner, no gas flow, or vapour lock at the coupling nut to the gas cylinder.
  • C
    Christina KnightAug 20, 2025
    How to stop gas leaking from Wesco asador 86 Grill hose?
    • J
      James CharlesAug 20, 2025
      If gas is leaking from a cracked, cut, or burned hose on your Wesco Grill, immediately turn off the gas at the gas cylinder or at the source on natural gas systems. If the hose is cracked or cut but not burned, simply replace the valve/hose/regulator. However, if the hose is burned, stop using the grill until a plumber or gas technician has investigated and corrected the problem. This issue is due to a damaged hose.
  • S
    sarachavezAug 25, 2025
    What to do if fire is coming through the Wesco Grill control panel?
    • A
      Allen CareyAug 25, 2025
      If you notice fire coming through the control panel of your Wesco Grill, immediately turn off the control knobs and gas cylinder valve. Leave the lid open to allow the flames to die down. After the fire is out and the grill is cold, remove the burner and inspect it for spider nests or rust. This issue is often caused by a fire in the burner tube section of the burner due to a blockage.
  • V
    Vincent BlankenshipAug 28, 2025
    Why are the sparks weak on my Wesco Grill?
    • G
      Gary TuckerAug 28, 2025
      If sparks are present but not at all electrodes or not at full strength on your Wesco Grill, check the following: 1. Ensure all output connections are securely connected at the module and electrodes. 2. Inspect for electrical arcing between output wires and the grill frame in a dark location. Replace wires if insulation is damaged. 3. Replace the battery with a new AAA-size alkaline battery if sparks are weak or at a slow rate. 4. Remove moisture from the electrodes with a paper towel if they are wet. 5. Replace cracked or broken electrodes if sparks are occurring at the crack. Possible causes include disconnected output connections, electrical arc between output wires and the grill frame, a weak battery, wet electrodes, or cracked/broken electrodes.
  • M
    Melanie CollinsAug 31, 2025
    Why no spark on Wesco asador 86 Grill?
    • H
      Heather GardnerSep 1, 2025
      If no sparks appear at any electrodes and no noise can be heard from the spark module when you turn the control knob on your Wesco Grill, it could be due to the following reasons: * The battery is not installed properly. Check the battery orientation to ensure that the '+' and '-' connections are correctly aligned. * The battery is dead. Replace it with a new AAA-size alkaline battery.
  • J
    John DunnSep 5, 2025
    Why is my Wesco asador 86 Grill gas cylinder leaking?
    • D
      David WhiteSep 5, 2025
      If gas is leaking from the gas cylinder of your Wesco Grill, it could be due to mechanical failure from rusting or mishandling, in which case you should replace the gas cylinder. Alternatively, it could be a failure of the cylinder valve from mishandling or mechanical failure; in this case, turn off the gas cylinder valve and return the gas cylinder to your gas supplier.
  • S
    Sean WaltersSep 8, 2025
    What to do if gas is leaking between the gas cylinder and regulator connection on my Wesco Grill?
    • J
      Jon JimenezSep 8, 2025
      If you notice gas leaking between the gas cylinder and regulator connection on your Wesco Grill, turn off the gas cylinder valve. Then, remove the regulator from the cylinder and visually inspect the rubber seal for damage. This issue is often caused by improper installation, a connection that isn't tight, or a failure of the rubber seal.

Wesco asador 86 Specifications

General IconGeneral
BrandWesco
Modelasador 86
CategoryGrill
LanguageEnglish