Need help?Do you have a question about the Wesco WS3202K and is the answer not in the manual?
Read all safety warnings, instructions, illustrations, and specifications provided with this power tool.
Keep work area clean and well lit. Avoid explosive atmospheres and keep children and bystanders away.
Ensure power tool plugs match outlets. Avoid body contact with earthed surfaces and protect cord from damage.
Stay alert, use personal protective equipment, and prevent unintentional starting. Do not operate while tired or under influence.
Follow instructions for safe tool operation, maintenance, and storage to prevent accidents and ensure longevity.
Wear hearing protection, use auxiliary handle, and be cautious of hidden wiring or cord contact.
Start drilling at low speed, maintain bit alignment, and avoid excessive pressure to prevent bending or loss of control.
Always wear a dust mask when operating the hammer tool to protect respiratory health.
Understand symbols for reading instructions, wearing protection, warnings, and double insulation.
Read the instruction book carefully before using the tool for proper operation.
The machine is intended for hammer drilling in concrete, brick, stone, and light chiseling work.
Attach and secure the auxiliary handle clockwise to loosen and counter-clockwise to tighten for safe operation.
Loosen the lock screw, insert the depth gauge, adjust depth, and tighten the screw to set drilling depth.
Protect dust cap. Insert bit with twisting motion until latched; remove by retracting locking sleeve.
Depress the On/Off switch to start the tool and release it to stop.
The anti-vibration handle enhances comfort and security during operation.
Fit the dust cover over the drill bit before drilling for dust protection.
Set hammer/chisel selector to 'T' and hammer/drilling selector to 'T' for hammer drilling.
Set hammer/chisel selector to 'T' and hammer/drilling selector to '舍' for drilling.
Set hammer/chisel selector to 'T' and hammer/drilling selector to 'T' for chisel work.
Refill grease when hammer efficiency is low by opening cover and adding general purpose lithium based grease.
The safety clutch stops spindle if bit jams, preventing high reaction torque and injury.
General| Power Source | Corded Electric |
|---|---|
| Rated Input Power | 800 W |
| Power | 800 W |
| No-load Speed | 0 - 1100 rpm |
| Drilling Capacity in Concrete | 26 mm |
| Drilling Capacity in Steel | 13 mm |
| Drilling Capacity in Wood | 30 mm |
| Chuck Type | SDS-Plus |
| Impact Energy | 3.0 J |
To Next Page
