To Next PageTo Next Page
Need help?Do you have a question about the Wesmar HD800/60-8 and is the answer not in the manual?
Tracking fish schools with GPS and displaying vertical profiles of schools.
Using the function knob and select switch to access and change settings.
Instructions for installing the console and monitor inside the vessel.
Step-by-step instructions for wiring the power cable to the console.
Instructions for connecting the interconnect cable between components.
Guidance on installing the seachest, including location and fabrication.
Optimal placement of the seachest on the vessel hull for performance.
Recommended seachest lengths for different hoist types.
Required inside diameters for seachests based on sonar model.
Step-by-step instructions for installing the lead screw hoist.
Determining the minimum length of the soundome tube for the seachest.
Steps for connecting the soundome tube to the soundome assembly.
Assembling the components of the lead screw hoist.
Adjusting the soundome's vertical position within the seachest.
Wiring the motor for the lead screw hoist system.
Verifying proper operation and travel distance of the lead screw hoist.
Key operational check points for both lead screw and ram hoist systems.
Installation instructions specific to the HD800 with Ram Hoist.
Determining soundome tube length for ram hoist installation.
Steps for attaching the soundome tube to the soundome for ram hoist.
Assembling the components of the ram hoist.
Adjusting the soundome's vertical position for ram hoist.
Wiring the motor for the ram hoist system.
Connecting power to the ram hoist control board.
Wiring the soundome cable for ram hoist.
Verifying proper operation and travel distance of the ram hoist.
Installation procedures for hydraulic hoist systems.
Installation of hydraulic hoists and soundome tubes for specific models.
Wiring instructions for hoist systems, including DC and AC.
Specific wiring instructions for DC hoist motors and control boards.
Specific wiring instructions for AC hoist motors and control boards.
Key operational check points for proper hydraulic hoist system function.
Crucial pre-operation checks for hydraulic system installation.
Verifying proper soundome movement and hoist operation.
Diagnosing and resolving common operational issues.
Troubleshooting motor problems like not raising or lowering.
Troubleshooting when the hoist raise and lower functions are reversed.
Troubleshooting when the motor runs after reaching its stop.
Troubleshooting why the soundome does not remain in the up position.
Calibration procedures for optimal sonar performance after installation.
Adjusting the console's positive 5 VDC output.
Adjusting the console's TVG offset for signal compensation.
Adjusting J-box components for optimal signal reception.
Adjusting the receiver gain on the console for signal strength.
Adjusting power supply frequency to minimize noise interference.
Pre-operation checks for FT hydraulic systems.
General