Wessex 15892 - User Manual

Questions and Answers

E
evan90Aug 6, 2025
Why my Wessex Vacuum Cleaner does not start?
- J
  John MoralesAug 6, 2025
  If your Wessex Vacuum Cleaner isn't starting, there are a few potential reasons: * It might not be properly connected to the power supply. Make sure it's plugged in securely. * There could be a defect with the power cord or plug. In this case, it's best to have it checked by a qualified electrician. * There may be another electrical issue within the product itself, which would also require inspection by a specialist electrician.
A
Annette CastroAug 12, 2025
Why is my Wessex 15892 not reaching full power?
- R
  Rebecca BurnsAug 12, 2025
  If your Wessex Vacuum Cleaner isn't reaching full power, consider these possibilities: * The extension cord you're using might not be suitable for the vacuum cleaner. Try using a proper extension cord. * The power source, like a generator, might have too low voltage. Connect the vacuum to another power source. * Air vents, the air inlet, or the air outlet could be blocked. Ensure these are clean and free from obstructions. * The safety valve might be activated due to too much water in the tank. Drain the excess water.
T
Tiffany BradleyAug 17, 2025
How to improve Wessex Vacuum Cleaner unsatisfactory result?
- E
  Eric Adams MDAug 17, 2025
  If you're experiencing unsatisfactory results with your Wessex Vacuum Cleaner, consider the following: * The attachment might not be suitable for the surface you're cleaning. Use the proper attachment for the job. * The dust bag might be full or damaged. Replace it with a new one. * The dust filter might be damaged. Replace it with a new dust filter. * The attachment, extension tube(s), or hose might not be well connected. Check and reconnect these parts securely. * There might be a blockage in the attachment, extension tube(s), hose, handle, or air inlet. Remove any blockages. * The attachment, extension tube(s), hose, handle, or air inlet could be defective. Replace the involved part with a new one.
J
jimenezdennisAug 25, 2025
Why is dust not being retained in my Wessex 15892 Vacuum Cleaner?
- L
  linda49Aug 25, 2025
  If dust isn't being retained in your Wessex Vacuum Cleaner when dry vacuuming, check these: * The dust bag or dust filter might be worn. Replace them with new, suitable parts. * The dust bag or dust filter might not be properly attached. Check and re-attach them correctly. * There could be a defect in the attachment, extension tube, hose, handle, or air inlet. Replace the faulty part with a new, suitable one.
T
Tamara KimAug 30, 2025
How to reduce excessive vibration or noise in Wessex 15892?
- M
  Michael MatthewsAug 30, 2025
  If your Wessex Vacuum Cleaner is experiencing excessive vibration or noise, check the following: * Ensure that the attachment, extension tube(s), or hose are properly connected. Re-connect if necessary. * Check for loose screws, bolts, or nuts on the handle or caster. Tighten them as needed.