First o, thank you for your purchase! We hope our products and service exceed your expectations for many years. So ... a little
background is in order. We are small company based in Sonoma County, California. We started out making Custom Shop boards and
cases per our customers' specications. We later introduced our Standard Series, a great product for all levels of players that feature the
most popular colors, sizes and features that were selected through our Custom Shop. We use the same high quality materials, and build
each Standard Series board just as meticulously as in the Custom Shop. Our goal is to make high-quality, hand made in the USA pedal
board systems that all players can enjoy. We source as many materials from within our main 50 states as possible. Each board and
accessory goes through an intense build procedure with many small detail checks and rigorous quality control standards. With your
proper care, our products should last a lifetime!
Whats Included:
Pedal Board and/or Case plus the Standard Accessory Kit including: this instruction sheet,
2’ of 1” industrial strength loop velcro, a variety of black plastic cable straps for securing
cables, and 1/2” screws to mount the cable straps. If your board has a power inlet, one(1)
six(6’) foot power cable will also be provided. Picks will be sent when available.
Care Recommendations:
General:
As a good practice for any instrument, we recommend avoiding excess moisture or getting your pedal board wet; it should be handled
with the same care as other ne instruments. This will assure years of good looks and function.
Coverings: Tolex & Tweed ‘s:
Make sure ALL power (if applicable) to the board is fully disconnected before cleaning. We oer many types
of coverings, from standard tolex and tweeds, to rare and vintage materials that are one-of-a-kind. The care
procedure is similar to all materials so lets get to it. All covering materials can be easily cleaned using warm
soapy water on a damp CLEAN cloth. Some of the materials are pourous and will absorb some of the
cleaning solution; we recommend testing your procedure on a small hidden section rst.
Pedal Board Deck:
The top portion of the pedal board receives most of the wear and tear. We use an EXCLUSIVE material called
Super Loop, a high strength velcro loop material. When removing pedals, carefully slide a credit card
underneath the pedal; seperating the pedal from deck.
Audio Connectors:
our 1/4” jacks are high quality switchcraft connectors; we solder Mogami cable to Switchcraft right angle 90’s for the ultimate in
reliability & clarity. All of our cable assemblies are soldered & have a limited lifetime guarantee.
Power Input:
All IEC outlets are rated at the US standard of 110V and 15Amp Maximum rating. Though these can work in other regions and other
voltages, using them with any other voltage and/or amperage WILL VOID any and all warranties provided by West Coast Pedal Board
and/or 3rd party companies whom parts we use to build our product. If you are in any way not sure about these details, please call our
shop or talk to a qualied electrical technician.
USER GUIDE & WARRANTY INFO
PAGE 1 ver 2 Standard Series - MAY 4th 2015
STANDARD SERIES
By
ONLY CONNECT THE ELECTRICAL LINE CORD TO AN EARTH GROUNDED RECEPTACLE.
[
110 VOLT RATED ]
DO NOT USE THE ACCESSORY OUTLET FEATURE FOR POWERING OTHER HIGH DRAW DEVICES SUCH AS AMPLIFIERS
OR P.A SYSTEMS. THIS CAN CAUSE UNWANTED INJURY, DAMAGE AND/OR RESULTS. UNPLUG THE AC POWER CORD
BEFORE CLEANING THE BOARD. TO PREVENT DAMAGE, FIRE OR SHOCK HAZARD, OR DEATH, DO NOT EXPOSE THIS UNIT
TO RAIN OR EXCESS MOISTURE. ONLY USE AN APPROVED ELECTRICAL LINE CORD WITH THIS DEVICE..
ALL ELECTRONIC REPAIRS SHOULD BE DONE BY A QUALIFIED ELECTRICIAN OR MUSIC REPAIR SHOP.
To Next Page
Need help?
General