Westbo of Sweden
Westbo Classic Preparations
Preparation
If you are installing your stove top, rst measure the
center of chimney and prepares cutout in the ceiling.
Be careful to follow the chimney supplier’s instructions.
Should you connect rear, follow the instructions bellow.
1. Measure out the center of the hole 1735 mm.
2. Use suitable tools to make the hole approximately
5,5-6 inch to t the spigot (ue pipe is 5 inch).
3. We recommend that you use a ue spigot.
4. Insert the ue pipe into the spigot then connect with
the stove seal between the spigot and ue pipe
(preferly seal rop).
The pipe should not go into the actual chimney, cut if
necessary.
Apply additional sealant for other joints.
5. Important! If your connection kit includes a rosette
collar to cover the hole in to the chimney put it on
before connecting the stove.
6. Contact the chimney sweeper for an inspection.
To Next Page
Loading...