Westco 5500 - User Manual

Questions and Answers

E
espinozajeromeAug 19, 2025
What to do if Westco 5500 jaws fail to grip tubing?
- B
  Benjamin DiazAug 19, 2025
  If the jaws of your Westco Industrial Equipment are failing to grip the tubing, consider these possible causes: Improper tong suspension may be the issue. Dull dies can also prevent a good grip, so replace or clean them with a wire brush. A worn brake band can cause grip failure, so replace it. Finally, using an improper jaw size will obviously affect grip, so consult the jaw size charts to ensure you're using the correct size.
M
Michael SchneiderAug 27, 2025
Why is my Westco 5500 Industrial Equipment tong failing to shift or difficult to shift?
- R
  Rebekah NewmanAug 27, 2025
  If your Westco Industrial Equipment tong fails to shift or is difficult to shift, the shifting mechanism might be worn, requiring replacement. Also, attempting to shift at high RPM can cause issues, so shift at a lower RPM or after a momentary stop, and ensure you shift with the rotor opening at the rear of the tong.
N
Nathan SanchezNov 4, 2025
How to troubleshoot a Westco 5500 Industrial Equipment tong running too slowly?
- B
  benjamin97Nov 4, 2025
  If the Westco Industrial Equipment tong is running too slowly, several factors could be responsible. First, the pump intake line might be plugged, requiring you to clean the intake line and filter. Second, the reservoir oil level could be too low, so you should add oil. Third, there might be an air leak in the pump intake line, which you can identify and repair. Fourth, the pump speed might be too slow, so check the manufacturer's speed recommendations and the actual speed of the pump. Vane type pumps will not prime if running too slowly. Fifth, the pump or tong could be excessively worn or damaged, in which case you should replace them, following the manufacturer's recommendations. To determine which is defective, disconnect the pump from the motor and test the pressure and volume of the ...
M
Martin RamosNov 11, 2025
Why won't my Westco 5500 Industrial Equipment tong produce sufficient torque?
- V
  vanessaarnoldNov 11, 2025
  If your Westco Industrial Equipment tong will not produce sufficient torque, consider the following potential issues: * The tong valve or relief valve on the tong may not be working due to a stuck valve. Check for dirty or gummy sludge, contamination of oil, or a broken spring valve. Alternatively, the valve could be leaking, so inspect the valve seat for damage, check the oil seals, and look for particles stuck under the valve stem. * Stuck, worn, or damaged pump parts can also cause this issue, requiring inspection and cleaning. * Ensure the pump speed is adequate by checking the motor speed. * Oil viscosity problems can also cause insufficient torque. If it's too high, some pumps won't prime; check the viscosity at working temperature and initial temperature. If it's too low, t...