Need help?Do you have a question about the WESTECH Beat NX-8252 and is the answer not in the manual?
Charge the headphones using a USB cable until the indicator light turns off. Full charge takes 2-3 hours.
Connect headphones to a Bluetooth device by enabling Bluetooth, searching, and selecting the headphones to pair.
Put on the headphones to receive audio directly from your paired Bluetooth device.
General| Connectivity Technology | Wired |
|---|---|
| Driver Size | 40mm |
| Frequency Response | 20Hz - 20kHz |
| Impedance | 32Ω |
| Cable Length | 1.2m |
| Connector | 3.5mm |
To Next Page