Why does my Westinghouse Washer have an imbalance error?
An imbalance error on your Westinghouse washer can occur for a few reasons: * The appliance is tilted. * Laundry is gathered to one side. * Non-distributable items are in the drum.
What causes a drain error on a Westinghouse LF 708C?
A drain error on your Westinghouse Washer means that water has not drained enough within 5 minutes.
What causes a lock error on a Westinghouse LF 708C?
A lock error on your Westinghouse washer could be due to: * The Connector (3-pin, male, white) in the wire harness is not connected to the Connector (3-pin, female, white) of MOTOR. Suggested solution: Reconnect or repair the connector. * The electric contact between the connectors 3-pin, male, white in the wire harness and 6-pin, female, white in the PWB ASSEMBLY (Main) is bad or unstable. Suggested solution: Reconnect or repair the contact in the connector. * The wire harness between the MOTOR and PWB ASSEMBLY (Main) is cut (open circuited). Suggested solution: Repair the damaged (open-circuited) WIRE HARNESS. * The hall sensor is out of order/defective. Suggested solution: Replace the PWB ASSEMBLY (Main).
What causes a current error on a Westinghouse LF 708C Washer?
A current error on your Westinghouse Washer indicates that either: * The PWB ASSEMBLY (Main) is out of order. Suggested solution: Replace the PWB ASSEMBLY (Main). * The winding in the MOTOR is short-circuited. Suggested solution: Replace the MOTOR.
What does it mean when my Westinghouse Washer shows a water inlet error?
A water inlet error on your Westinghouse Washer means that water has not reached the pre-set level within 4 minutes since the inlet valve operated, or water has not reached the normal level within 25 minutes.
What does overflow error mean on a Westinghouse Washer?
An overflow error on your Westinghouse Washer means that water is automatically being pumped out because there is too much water in the tub.
What does it mean when my Westinghouse Washer shows a door open error?
A door open error on your Westinghouse Washer can occur if: * The Start/Pause button is pressed with the door open. * The door switch is out of order.
What does heating error mean on Westinghouse LF 708C Washer?
A heating error on your Westinghouse Washer indicates that the thermistor is out of order.
General| Brand | Westinghouse |
|---|---|
| Model | LF 708C |
| Category | Washer |
| Language | English |
Provides step-by-step instructions for the correct installation of the appliance.
Provides essential safety precautions and preliminary checks before service.
Details the procedure for entering and utilizing the Quality Control test mode.
Explains how to check water level frequency for diagnostic purposes.
Lists common error codes, their symptoms, and potential causes for diagnosis.
Guides through diagnosing and resolving common operational issues and symptoms.
Provides detailed troubleshooting steps for specific faults like no power or water supply issues.
Step-by-step instructions for safely disassembling the control panel assembly.
Guides on how to disassemble the detergent dispenser unit.
Detailed instructions for removing and disconnecting the water inlet valve.
Procedure for opening and removing the appliance's lower cover plate.
To Next Page
