Westinghouse SR51FB22C-08 - User Manual

02/28/2020
E
REPLACING THE BATTERY
TROUBLE SHOOTING
INSTRUCTIONS
Tools Required
Phillips-head
Screwdriver
Pencil
Electric drill
drill bit size:
ø7.5mm (3/10 in.)
INSTALLATION
Drill two holes.
1 Marking the location
Measure the width of two holes on the back of the solar fence
light to align holes for the 2 screws (Part A) on the surface. The
distance between the two holes is 2.36in. (60mm).
Mark the location where you want to mount the light xture (Part C).
2 Mounting the light
Insert the wall anchors (Part B) so they are ush with the surface.
x
x
2.36in.
FOR FIRST TIME USE: SOLAR LIGHT NEEDS TO CHARGE IN FULL SUNLIGHT FOR 8 -12 HOURS WITH THE SWITCH IN
THE “ON” POSITION TO ALLOW THE RECHARGEABLE BATTERIES TO REACH MAXIMUM CAPACITY.
The intelligent solar LED motion activated light measures the corresponding available battery power through the current voltage point of
the battery, adjusts the energy and lumen output, and maximizes the lighting time.
Hardware Included
Parts
(B) Wall Anchor X 4(A) Screw X 4
(C) Light Fixture X 2 (D) Mounting Plate X 2
Secure the mounting plate (Part D) in place with the screws (Part A).
Mount the light on the mounting plate (Part D) by aligning the holes
on the back of the light to the key on the front of the mounting plate.
Slide and lock into place.
B
A
D
C
Slide the power switch to the "OFF" position. Use a
Phillips head screwdriver to remove the 6 screws
holding the battery cover in place. Gently pull battery
pack away from the light xture and disconnect the
battery connector. Replace old battery pack with a
new 3.7V, 2000 mAh lithium (18650) rechargeable
battery pack. Connect the battery connector and insert
battery pack into the light xture. Replace the battery
cover by aligning it properly and replacing the 6 screws
removed earlier. Slide the power switch to the “ON”
position.
For optimum performance, allow light xture to charge
in full sunlight for 8-12 hours.
ScrewsPower Switch
Battery pack
Battery Cover
If the light does not turn on, remove the
battery cover and check if the battery
pack is connected to the battery
connector. If the connection is ok,
replace the battery with a new one.
INTELLIGENT SOLAR LED MOTION ACTIVATED
FENCE LIGHT
ITEM: SR51FB22C-08
NOTE: Light will stay on 30 seconds when triggered by motion. Detection range is 26 feet, detection angle is 120°. Light use radio frequency
technology to link, and should not be greater than 98 feet between the neighboring/adjacent lights. The package include 2 lights.
These 2 lights is factory linked, and can not linked any other lights.

Summary

Instructions

Initial Charging for First-Time Use

Charge the solar light in full sunlight for 8-12 hours with the switch ON for maximum battery capacity.

Installation and Mounting Guide

Details on required tools, included hardware, marking the location, and securing the light fixture.

Troubleshooting

Light Not Turning On

Check battery pack connection and replace with a new one if issues persist.

Replacing the Battery

Battery Replacement Procedure

Steps to remove, replace, and secure the battery pack, including switching to ON position.

FCC Warning and Compliance

RF Exposure Information

Equipment complies with FCC radiation exposure limits; maintain 20 cm distance from radiator.

Battery Disposal Warning

Do not dispose of lithium batteries in municipal waste or fire; follow regulations for disposal.

Westinghouse SR51FB22C-08 Specifications

General

Brand	Westinghouse
Model	SR51FB22C-08
Category	Outdoor Light
Language	English