WESTLOCK CONTROLS
280N MIDLAND AVENUE, STE.258, SADDLE BROOK, NJ 07663 TEL: 201-794-7650 FAX: 201-794-0913
www.westlockcontrols.com
12/20/2017 TECH-533/ D.W.O. 22902 Page 9 of 20
Figure 2
Mounting for Shaft Option Direct Mount to Keystone 79U or MRP Actuators
4.2 Pneumatic piping:
Single Acting Actuator (Spring Return):
For single acting actuators Outlet Port 2 is to be plugged. Outlet Port 1 is to be piped to the
actuator inlet port that acts against the spring. (Increasing signal causes pressure to increase in
Outlet Port 1 of the positioner).
Double Acting Actuator (Double Return):
For double acting actuators Outlet Port 2 is piped to drive the actuator towards the fail
Position. Outlet Port 1 is piped to drive the actuator away from the fail position.
(Increasing Signal causes pressure to increase in Outlet Port 1 of the positioner and pressure to
Decrease in Outlet Port 2 of the positioner
Figure 3 Standard Flow Manifold Figure 4 High Flow Manifold
Bracket
(Included with D option)
To Next Page
Loading...