3
OPERATIONAL ADVICE
First - Turn down and turn o any external devices (ampli ers / active loudspeakers etc) which you will
be connecting the WF-300 audio output cables to. Then, with all power switched o , make the
appropriate audio connections from the WF-300 to your ampli cation system.
Insert the batteries into the WF-300 microphones.
With all volumes set to a minimum, turn ON the power of the WF-300 and then turn on your
connected audio system.
Now adjust the volume of the receiver (rack) to the middle, then turn on the microphones. Talk
directly into the microphone, then adjust the volume as required.
After use, turn down and turn o the power of your audio system. Then o the power of the WF-300
transmitter (mic) & receiver (rack).
Note -
The angle and tilt of the rack antennae directly a ects the reception of the receiver, so pay attention
to the receiver placement and antennae angles. The most important principle is to keep the distance
short between the microphone and the receiver.
Avoid placing the receiver near any computer or equipment that can produce RF signals.
________
SYNCHRONIZING FREQUENCIES
On the front panel of the receiver (rack) select the channel you wish to use by pressing the or
arrow on the respective channel.
The LCD will display F - - - - -
Now place the microphone you wish to synchronize with near to the IR sensor on the front of the
WF-300 rack. The LCD of the microphone should face the rack.
Now check the LCD display of the microphone, the channel should be same channel with the receiver.
Then it is ready to use.
LOCK / UNLOCK
To avoid accidental changes being made to the system it is possible to LOCK channels. To enable
LOCK mode press the and the keys together. To UNLOCK repeat this operation.
If you encounter any problems please consult professional technicians or contact your dealer.
To Next Page