17
• Open the door and place a fresh bottle in the front of the tray.
• Clean the bottle cap and neck. Use a soft cloth soaked in a 3% bleach solution.
• Remove the entire plastic cap from the bottle.
• Push down on the probe head until it is rmly seated.
• Push the bottle inside of the compartment.
• Close the door gently.
NOTE: Round bottles can be easily loaded, as they have no sides. Rectangular bottles
will only go one way. The long side must be loaded front to back. Please see the dia-
gram below.
3. Plug the cord into a properly wired and grounded dedicated wall outlet.Water will be
pumped into the hot and cold water reservoirs from the bottle.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result
in serious injury, re or electrical shock.
To Next Page