EasyManua.ls Logo

Whirlpool ACE 010 IX - Initial Setup Procedures; Filling the Water Tank; Preheating the Coffee Unit

Whirlpool ACE 010 IX
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
1
2
FILLING THE WATER TANK
1. TURN THE APPLIANCE on by pressing the ON/OFF
BUTTON AND ATTACH THE FILTER HOLDER TO THE APPLI-
ANCE WITHOUT ADDING GROUND COFFEE.
q REMOVE THE WATERTANK by pulling it out (to-
wards the front).
N
EVER USE THE APPLIANCE WITHOUT WATER IN
THE TANK and always remember to top up
when the level drops to a couple of cen-
timetres from the bottom.
w FILL THE TANK with fresh
clean water taking care
not to exceed the MAX
level. Refi t the tank.
PREHEATING THE COFFEE UNIT
TO AT TACH THE FILTER HOLDER, position it under the
boiler outlet
with the han-
dle towards
the left,
push it
upwards
and at the
same time rotate the
handle fi rmly towards the right.
Check that the steam knob is closed.
2. P
LACE A CUP UNDER THE FILTER HOLDER. Use the
same cup as will be used to prepare the coff ee
in order to preheat it.
3. WAIT FOR THE OK INDICATOR
LIGHT to come on, then imme-
diately press the coff ee knob.
Run the water off until the OK
indicator light goes out, then inter-
rupt delivery by pressing the coff ee
button again.
4. EMPTY THE CUP. Wait until the OK
indicator light comes on again then repeat the
same operation. (It is normal for a small and
harmless puff of steam to be given off when
removing the fi lter holder).