Whirlpool ADP 4108/1 User Manual

WH/II/B/GB
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the
ON
/ OFF button.
Compartment
A:
With each wash cycle.
Compartment
B:
For programmes with pre-wash only.
If using combined action dishwasher
tabs, follow the user instructions!
Mechanical indicator
C
.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator
D
. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or knob).
The corresponding indicator lamp lights up.
If necessary (and if provided).
The corresponding indicator lamp lights up.
The selected programme is
then memorised (even in the
event of power failure).
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
Only after the START button has switched off: Press the ON /
OFF
button.
All the indicator lamps switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Switch on the appliance
Fill the detergent dispenser
ABC
Check the rinse aid level
Check the
regeneration salt level
Load the racks
Close the dishwasher door,
turn on the water tap
Select a programme
Select additional options
Press the Start button
“Change programme in progress”
Press the START button for 2 sec. until the
Start indicator lamp switches off.
Select another programme and press the
START button again.
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks

Whirlpool ADP 4108/1 Specifications

General

Type	Freestanding
Energy efficiency class	A
Washing class	A
Drying class	A
Number of programs	6
Delay Start	Yes
Dimensions (H x W x D)	85 x 60 x 60 cm

Summary

How to Use the Appliance

Appliance Preparation Steps

Steps for switching on, filling detergent, checking levels, and loading.

Programme Selection and Start

Guide to selecting programmes, options, and starting the wash cycle.

End of Cycle Procedures

Steps for switching off, turning off water, and unloading the appliance.

Dishwasher Loading Instructions

Upper Rack Loading

Details on loading the upper rack, including supports and height adjustment.

Lower Rack Loading

Instructions for loading the lower rack with plates and saucepans.

Cutlery Basket Usage

Guidance on using the cutlery basket for effective cleaning.

Troubleshooting Common Issues

Appliance Not Working

Checks for when the appliance does not start or function.

Crockery Not Dry or Clean

Causes and remedies for dishes not drying or cleaning properly.

Deposits and Discoloration

Addressing issues like residues, faded plastic, or opaque glasses.

Identifying Appliance Faults

Interpreting indicator lamps and fault codes for diagnosis.

Quick Reference Guide

Control Panel Overview

Description of buttons, knobs, and indicators on the appliance.

Programme Chart Details

Details of wash programmes, loading instructions, detergent, and consumption.