EasyManua.ls Logo

Whirlpool ED22DK - Before Using Your Refrigerator; Cleaning and Electrical Setup; Installation and Leveling Procedures

Whirlpool ED22DK
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
I
Before Using Your Refrigerator
3-prong grounding
type wall receptacle
Flefrigerato
power cord
3-proAg
grounding plug
Right to raise;
left to lower
Use screwdriver
Clean it
Clean your refrigerator before using it. See
cleaning instructions on page 12.
Plug it in
Recommended Grounding Method
A
115
Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical supply is
required. It is recommended that a separate
circuit serving only this appliance be provided.
Use a receptacle which cannot be turned off with
a switch or pull chain. Do not use an extension
cord.
See Electrical Requirements and Grounding
Instructions Sheet in your Literature Package.
Install properly
1.
Allow l/2 inch (1.25 cm) space on each side
and at the top of the refrigerator or ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side closest to the wall so the door can be
opened wider.
3. The refrigerator back can be flush against the
wall.
4. If your refrigerator has an ice maker, make
sure ice maker water supply has been
connected. Refer to Installation Instructions.
Level refrigerator-freezer
1.
Remove the base grille. (See page 9.)
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in direction shown.
4. Check with level.
5. Replace base grille. (See page 9.)
Leveling screw

Related product manuals