Install properly...
I
.
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
2. Allow at least an inch (2.5 cm) between the re-
frigerator condenser on the back and the wall.
3. Allow
Y2
inch (1.25 cm] on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be ooened wider.
Level refrigerator-freezer...
WER
1. Keep the 4 bolts that hold refrigerator in ship-
ping crate. They are the levelling legs.
2. Screw these bolts all the way into bolt holes
at the bottom corners of refrigerator. Roll
refrigerator into place.
3. Lower legs just enough to lift rollers off floor.
4. Adjust each until the refrigerator won’t rock.
5. Adjust front legs to level the refrigerator.
- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.
6. Check with level,
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re-
frigerator. To remove any remalning glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachlorlde, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet tastened under
the retrlaerator at the front.
Clean it...
jq/
Clean your refriger-
ator before using it.
See cleaning instruc-
’
tions on page 8.
f
Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGER
POWER CORD
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir-
cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package.
4
To Next Page
Loading...
