3. Hold
the surface unit as level as possible
with the terminal just started into the
receptacle.
Push
the surface unit terminal
into the receptacle.
4. When terminal is pushed into the recep-
tacle as far as it will
go, push down
the
edge of the surface unit opposite the
receptacle. The element hold-down clip
will keep the surface unit from moving
around.
NOTE:
Reflector bowls reflect heat back to
the utensils on the surface units. They also
help catch spills. When they are kept clean,
they reflect heat better and look new longer.
If a reflector bowl gets discolored, some of
your utensils may not be flat enough, or
some may be too large for the surface unit.
In either case, some of the heat that’s meant
to go into or around a utensil goes down and
heats the reflector bowl. This extra heat can
discolor it.
19
To Next Page
Loading...
