Gas and electrical connections
[] Appiy pipe-joint compound made
for use with LR gas to the smaller thread
ends of the flexiMe connector adapters.
Attach one adapter to the pressure
reguhtor eibovv' and the other adapter to
the gas shutoff valve+ Tighten both
adapters+
AH connections must be wrench-
tightened.
Typical rigid pipe connection
Use 5/16" combination wrench
and channel lock pliers to attach the
flexible connector to the adapters. Check
that connector is not kinked.
[] Test all connections by
brushing on an approved non-corrosive
leak-detection solution. Bubbles will
show a leak+ if a leak appears, shut off
gas supply valve and tighten
connections+Then check connections
again+ Clean aii leak+detection solution
from gas connections. Close broiler door.
[] Center the burner cap on
burner base, Burner cap should be level
when properly positioned+ Place burner
grates over burner+
pressure
regulator
@ j-union
manual gas
iron shutoff valve
pipe
90_elbow union nipple
I/2" to 3/4"
gas pipe
Typical flexible connection
pressure use pipe-joint manual gas
/ /
A !/2" male pipe use pipe-joint /
thread is needed for compound /
connection to 1/2" to 3/4"
pressure regulator gas pipe
female pipe threads.
[] Check that range regulator
shutoff valve is in the "on" position+
Open the manual shutoff valve in the gas
supply line+
regulator
shutoff valve in
"on" position
manual shutoff valve
in "open" position
to range _j_1_ +__
gas supply
[] Plug power supply cord into
grounded electrical outlet.
To Next Page
Loading...
